[diy] fusion necklace

 fusion necklace. 

materials :

1. wire

2. friendship band threads

3. button. 

4. fabric glue/ clear nail polish

5. paper and pencil

6. plier

 step 1. draw your design on a piece of paper, so that later on, you can use it as a guide to form your design. 

 step2. using wire sculpturing pliers, make the word. 

 step 3. cut friendship band thread of desired length, fold them in half, then make a loop and secure it to the 'dream'. do the loop like how you would to attach a ribbon to the bookmark. (i hope you get what i mean) 

step4. clip the 'dream' to a stack of paper, and tie friendship band knots to add some pattern. 

below is a step by step guide to doing the friendship band knot. 

 a. here, i am using 3 colours of thread. holding the pink and white together, place the purple thread below it. 

 b. bring the purple thread from beneath and loop it over the pink and white thread, 

then bring it below the purple thread again. then pull tight. 

repeat this 10 times for each coloured thread. 

note : you can do it for the entire length of the necklace, 

but if your thread is not long enough, do a little cheat like how i did it. 

step 5. end the necklace with a knot on 1 end, and a button on the other end. 

done!